Tools and materials:
Air compressor, nail and staple gun kit
In this video I make a simple bench / cabinet out of OSB. I basically made it for my mini machinist's lathe.
I begun by cutting my stock to size with a circular saw and it’s guide rail.
I then layed out my design. I created entry holes with a forstner bit and used my jigsaw to remove as much material as I had to. I tried to cut both sides at once by clamping them together.
I used some corner clamps to temporarily keep everything together. I then added some glue and nails. I secured everything in place with screws. I first pre drilled pilot holes, then I counter sinked them and finally I screwed them in place.
I then added the cleats before I place the top and bottom panel.
I also added a shelf.
I almost used a complete sheet of 15mm OSB for this project.
I actually cane out much more robust than I expected. But that was it see you soon with a new project video.
Disclosure: Some of the links below are affiliate links, meaning, that at no cost to you, I get a small commission if you click through and make a purchase.
No comments:
Post a Comment