Friday, September 13, 2019

How to make a wooden toy car - Woodturning















Tools and materials I propose:

In this video I make a minimalistic toy car, out of iroko and basswood.  This is a cool example of using the woodworking lathe to make toys. 

I begun with a square piece of iroko wood, on which I marked a few guide lines. I then moved on to the drill press and drilled the holes for the wheels. I used a forstner bit to create the seat for the driver. It was much easier to make the holes on square stock. After turning it would have beed much more difficult. 

I then roughed turned the stock with a roughing gouge. I created a dovetailed tenon with a skew chisel to fit my chuck. I then finished shaping the piece with the skew. I sanded the piece and finished it with polishing paste. I cleaned the back using a sanding adapter on the lathe. 

I then cut a piece of basswood to create the driver. I used the skew to shape him. Basswood and iroko create a nice contrast with each other. I then glued the driver in place.

To make the wheels I used my callipers to make my marks, so I can make them all the same. I used the skew and sand paper to shape them. I then I added a drill chuck on my tailstock and drilled the holes. I used the knife parting tool to cut them off and then sanded them. 

But I had a problem. The wheels were to small and the belly of the car touched the ground. I decided to make the back wheels a bit larger to solve the problem. But I did not have so thick material. So I turned the back wheels side grain. This created a bit of visual difference between the front and back wheels, but I was ok with that.  

The axles of my car are just 10mm dowels. The holes on the body of the car are 12mm. I glued the axles in place, trimmed them with a saw and sanded them flush.

I finished the car with mineral oil. 

My little car came out awesome. I hope you liked this one, because that was it, see you soon with a new project video!



Disclosure: Some of the links below are affiliate links, meaning, that at no cost to you, I get a small commission if you click through and make a purchase.

No comments:

Post a Comment